AP Pure Sine Wave Inverter

Features
1. EYEN AP Pure Sine Wave Inverter is a combination of an inverter, battery charger and AC auto-transfer switch into one complete system with its conversion efficiency being 80%.
2. Designed to use with AC electricity supplied from the generator or grid, it allows any surplus AC power to pass through to power downstream AC loads. When AC power is available, the inverter will recharge the batteries. When AC power is disconnected, the unit converts DC battery power into AC electricity.
3. This pure sine wave inverter is packed with features and it is one of the most advanced chargers in the market today. It features power factor correction, sophisticated multi-stage charging and pure sine wave output with unprecedented high surge capability to meet the power needs of inductive loads without damaging the equipment.
4. The high surge capacity of this pure sine wave inverter is 3 times of rated power, which enables it to run more difficult inductive loads and handle overload conditions.
5. Combined with a more sophisticated multi-stage battery charging algorithm, the max charging of the new power factor correction (PFC) rates to70A, which reduces electricity draw and generator run-time.
6. The built-in transfer switch of this pure sine wave inverter can automatically transfer between inverter power and incoming AC power in 10ms.
7. This inverter comes with durable power coating and corrosion resistant steel chassis Options.
8. It is designed with various protections including over / under voltage, overload, over-temperature and short-circuit protections, etc.
9. There's no battery in the bypass path.
10. The accessories of this pure sine wave inverter adopt remote control panel and 1 meter of battery cable.

Technical Parameters of AP Pure Sine Wave Inverter

Model	AP2012	AP2024	AP3012	AP3024
Input Voltage Waveform	Sinusoidal (utility or generator)
Nominal Input Voltage	230VAC
Low Line Disconnect	184VAC±4%
High Line Disconnect	253VAC±4%
Max. AC Input Voltage	270Vrms
Nominal Input Frequency	50Hz/60Hz (Auto detection)
Over-load Protection  (SMPS load)	Circuit breaker
Output short circuit protection	Circuit breaker
Efficiency (Line Mode)	>95%
Transfer Switch Rating	30A
Transfer Time(Ac to Dc)	20ms (typical)
Output Voltage Waveform	Sine wave
Rated Output Power (w)	2000	2000	3000	3000
Power Factor	0~1.0
Nominal Output Voltage (V)	230VAC
Output Voltage Regulation	±10%rms
Nominal Efficiency	>80%
Nominal DC Input Voltage	12V	24V	12V	24V
Nominal Charge Regulation	70A	35A	70A	35A
Charge Current Regulation	±5Adc
Battery initial voltage	0-15.7Vdc (can operate with 0 V battery)
Communication	RJ11 (Used for factory testing. No customer interface available)
Safety Certification	Compliance with UL458		CE(EN60950)
EMI Classification	FCC,CLASS A		EN50091-2,CLASS A
Operating Temperature Range	0℃~40℃
Storage temperature	-15℃~60℃
Operation humidity	5% to95%
Audible Noise	Max. 60dB
Cooling	Forced air, variable speed fan
Size	381mm*217mm*179mm