Products
AC Converter / Battery Charger
- LiFePO4 Battery Pack
- Power Quality Products
- Off-Grid Inverter
- MPPT Solar Charge & Discharge Controller
- AC Converter / Battery Charger
-
AC Automatic Voltage Regulator
- 1st Gen Servo Type Voltage Stabilizer
- 2nd Gen Relay Type Voltage Stabilizer
- 2nd Gen Servo Type Voltage Stabilizer
- 3rd Gen Relay Type Voltage Stabilizer
- 3rd Gen Servo Type Voltage Stabilizer
- Smart Power Strip Type Voltage Stabilizer
- Wall Mounting Type Voltage Stabilizer
- Contact Type Voltage Regulator
- Step-Up & Down Transformer
- Uninterrupted Power Supply
0102030405
CSB Series AC Converter / Battery Charger DC12V/24V 36V/48V AC 110V/220V 1000W 2000W for RV/Motorhome/Trailer
product detail
| Input | |||
| Input Voltage | CSBXXHXX | 184-286Vac full performance | |
| 90-184Vac automatically derates to 50% of current Settings. | |||
| CSBXXLXX | 96-145Vac full performance | ||
| 70-96Vac automatically derates to 50% of current Settinqs. | |||
| Frequency | 40Hz to 70Hz | ||
| Nominal Input Current at Rated Output | <9Aac | ||
| Voltage Measurement Accuracy | ±8Vac | ||
| Frequency Measurement Accuracy | ±1Hz | ||
| Output | |||
| Nominal Voltage | CSBXXXXX： XX： 10： 1000W： 20:2000W X： H/L(lnput Voltage Type) XX： 12/24,36/48,12,24,36(48(Battery Voltage Type) | ||
| CSB10X1224 | CSB10X3648 | CSB20XXX | |
| Output Current | 75A/37.5A | 25A/18.75A | 120A 60A 40A 30A |
| Rated Output Current | Manual adjustable | ||
| Current Accuracy | ± 6% of full rated output current @25°C, for target currents across the range from 10% rated output (for absorption exit criteria accuracy) to the current limit set point. | ||
| Load Regulation | 1.5% | ||
| Battery type selected | Four charging voltages can be adjusted manually | ||
| Parallel Outputs | Maximum of two AC converter units connected in parallel | ||
| Efficiency | 80% | ||
| Protection | |||
| Input Over/Under Voltage | When the voltage is within the input voltage range, the device must be safe.Shutdown or input current limit or other means may be applied when input voltage is out of normal operating range. | ||
| Reverse Battery Polarity Protection | Non-destructive reverse battery polarity protection with fuses. Unit shall not sustain damage and shall meet all specifications after fuse replacement. | ||
| Output over voltage | Unit will shut down if Vcharging > Vcharging (target) + 1,0Vdc/1.5Vdc/2.0Vdc/2.5Vdc for more than 2 seconds; unit will restart when voltage <= Vcharging (target) for more than 2 seconds. | ||
| Charger over temperature protection | The internal temperatures of the charger will be measured by NTC. Based on these measurements, unit will shut down if the temperature exceeds 105°C. Unit will restart when environment temperature cools to 95 °C. | ||
| BTS(Battery Temperature Sensing) | The battery temperature sensor allows the charge controller to continuously adjust charge voltage / charge current based on actual battery temperature. When the battery temperature is over 40 °C, unit will reduce the charging voltage to Float voltage, also it will reduce the Max charging current by 10% with every two degree of temperature rise. When the battery temperature is over 50 °C,unit will shut down. |
||
| 4.4 Environmental | |||
| Operation temperature | Nominal ambient temperature: 25°C Operating Ambient Temperature range: -10°C to40°C (On the heat sink of DC-DC part, if the temperature is over 90 'C, the Charger Current will be derate to 50% : if the temperature is over 105 C, the Unit will be shut down.) | ||
| Relative humidity | 5〜95% without condensation | ||
| Noise | Unit requirements: below 50dB (A) measured at 1 m distance with fan full working. | ||
| Storage Conditions Temperature | -20°C to +80°C |
||
| Cooling | Smart fan control |
||
| Condition | Speed | ||
| Heat Sink Temperature | T＜50℃ | OFF | |
| 50℃≤T＜60℃ | 50% | ||
| T≥60℃ | 100% | ||
| Charger Current | I <15% | OFF | |
| 15%≤ I ＜25% | 50% | ||
| I ≥25% | 100% | ||
| Safety | UL458，CSA22.2#107.1 | ||
| 4.5Mechanical | |||
| CSB10XXX | CSB20XXX | ||
| Dimension (D x Wx H) mm | 261.4*160*70(mm) | 307.4*180*82(mm) | |
| Unit Weight | 2.65Kg | 4.0Kg |
|
| Gross Weight | 2.9Kg | 4.2Kg | |
- Previous: 1st Gen PSW7 Series Pure Sine Wave Inverter, Charger 1kw-6kw
- Next: 2.56Kwh Energy Storage System LiFePO4 battery pack