PG Series Modified Sine Wave Inverter

Short Description:

Product Detail

Product Tags

PG Modified Sine Wave Inverter

PG modified sine wave inverter is a combination of an inverter and a charge. It offers a smart, convenient and economic way to get AC power supply from DC source for most electrical equipment. When the AC input is available, it will switch to AC power supply and starts charging on the batteries.

Features1.With high frequency design and modified sine wave output, the modified sine wave inverter offers high efficiency.2.Automatic switch between mains power and battery power supply.3.Rack tower design, compact size for convenient use and storage4.Off mode charging function is available5.Selectable switch for wider input voltage.6.Full automatic and silent operation7.Built-in 10Amp super charger for up to 100Ah battery8.Two-step intelligent charging control system is available to control recharging time.9.The modified sine wave inverter comes with informative LED indicator and alarming functions.10.Full protections against various abnormal situations11.Different AC outlet configurations are available: NEMA, Schuko, French, India, and BS136312.This is a small scale and cost effective modified pure sine wave inverter for home appliances and office equipment.

Technical Specifications

Slide to the left for full table
Model PG 500 PG 1000 PG 2000
Capacity VA/W 500VA / 300W 1000VA / 600W 2000VA / 1200W
Input Phase Single
Voltage 110 / 120VAC or 220 / 230 / 240VAC
Voltage Range 90 – 145VAC or 170-280VAC ( Narrow Range )
50-145VAC / 90-280VAC (Wide Range)
Output Phase Single
Voltage 120VAC or 230VAC
Voltage Regulation(Batt. Mode) +10% ~ 18%
Frequency 50Hz or 60Hz
Frequency Regulation (Batt. Mode) +/- 0.1 Hz
Output Waveform (Batt. Mode) Modified Sine Wave
Power factor P.F. 0.6
Battery Charger Current 8 Amp + / – 1Amp 6 Amp + / – 1Amp 10 Amp + / – 1Amp
Floating Voltage 13.7V + / – 0.2V 27.4V + / – 0.4V 27.4V + / – 0.4V
Overcharge Protection 15V +/- 0.3V charger stops and fault 15V +/- 0.6V charger stops and fault 30V +/- 0.6V charger stops and fault
Transfer time Typical 8ms
Efficiency AC to AC >95%
DC to AC >80%
Indicator AC Mode Solid Green LED
Battery Mode Solid Yellow LED
Battery Charging Mode Green LED flashes at 2 seconds intervals
Overload Red LED flashes at 0.5 second intervals
Fault Solid Red LED
Audible alarm Low Battery at Battery Mode Beeps at 2 seconds intervals
Overload Sounding at 0.5 second intervals
Fault Beeps Continuously
Protection Full Protection Deep Discharge, Overcharge, and Overload protection
Physical Dimension (L×W×H) mm 224 ×260 × 80
Net Weight (kgs) 1.7 1.9 2.5
Environment Operating Environment 0~40 Degrees Centigrade, 0~90% relative humidity (non-condensing)
Noise Level Less than 50dB

Note Product specifications are subject to change without prior notice.

  • Previous:
  • Next:

  • Write your message here and send it to us